18mm 02 sensor Weld-on 304 stainless steel O2 bung. Universal for the new small 18mm size oxygen sensors! Universal stainless steel weld-on o2 bung, could be welded to mild-steel,...
Universal 18mm titanium weld-on o2 bungs for titanium tubing/piping. Great for custom oxygen sensor location, place it where you like to prolong the sensor life and get better accuracy reading....
Weld-on mild steel O2 bung. Universal 18mm for most common wideband or OEM o2 sensors!Cap Not included.Universal mild steel weld-on o2 bung, could be welded to mild-steel, steel, and stainless...
Stainless Steel slip-on section that would step up 1.375" and 1.5" to 2", which would allow a muffler with 2" I.D. to slip over. The slip on section is perfect...
Chimera Dry Break Receiver Weld-On Flange! Will fit the most common single dry break female receivers on the market, such as IMS, Clarke, and RedHead. Customize an OEM gas tank...
12mm 02 sensor Weld-on 304 stainless steel O2 bung. Universal for the new small 12mm size oxygen sensors!Universal stainless steel weld-on o2 bung, could be welded to mild-steel, steel, and...
Weld on 2 bolt flange for Honda GET 49cc engines, used for custom exhausts.Great for DIY builders who would like to make their own GET 49cc exhaust or custom pluming...
Stainless Steel retaining springs for exhaust systems! Perfect for slip fit mufflers or headers. Available in various length, swivel on one end.Sold individually.Short 1.8"Medium 2.3"Long 3.0"Stainless steel muffler springs with...
M8 (5/16") Weld on bung, machined from 304 stainless steel! Universal for anything, we usually use these bungs for our custom exhaust hangers, weld to parts that will be bolted...
Stainless Steel retaining spring hook for exhaust systems! Perfect for slip fit mufflers or headers that needs a anchor retaining point for the spring to hook onto. Spring hooks are...
IMS Dry Break Flange Gasket! Will fit most common single dry break receivers flanges on the market, such as IMS, Clarke, and RedHead. This is a must to seal between...
For all those garage builders looking to build a custom high performance exhaust, look no further for a step cone! Sold individually.Machined from 304 stainless steel, could be used as...
Material is 304L Stainless Steel, 1mm wall thickness. Tube ends are cut to length and deburred for a clean, perpendicular end condition. Tubes are taper formed via mandrel dies to...
12mm 02 sensor Weld-on Titanium O2 bung. Universal for the new small 12mm size oxygen sensors!Universal Titanium weld-on o2 bung, could be welded to Titanium piping. Great for custom oxygen...
M8 (5/16") Weld on bung, machined from mild steel! Universal for anything, we usually use these bungs for our custom exhaust hangers, weld to parts that will be bolted onto...
