Aluminum RG Rear Sprocket for Benelli TNT 135cc
  • SKU: RG-1003-32

Aluminum RG Rear Sprocket for Benelli TNT 135cc

$49.95
Shipping calculated at checkout.
    DESCRIPTION
    Aluminum RG Rear Sprocket for Benelli TNT 135cc


    NOTE: Photos shown are for reference only, the actual sprocket is different as the TNT 135 is 6 bolt mounting, please ignore the photo! This is the correct rear sprocket for TNT 125/TNT 135!

    Aluminum RG Rear sprocket for Benelli TNT 135cc. These gears are manufactured from aircraft quality 7075 T651 Plate Aluminum. Harder than steel and far lighter to save on unsprung weight.

    Available in

    • -32T
    • -33T
    • -34T
    • -35T
    • -36T
    • -37T
    • -38T
    • -39T
    • -40T

    The stock rear sprocket size on the Benelli TNT 135cc is 36 tooth. You can go up to 37t or 38t to increase your acceleration at the expense of top end speed. If you go down to the 35t or 34T you can get a higher top end speed at the expense of acceleration. A few rules of thumb with gear ratios for sprockets are as follows:

    • Drop teeth on front/add teeth to rear = increased torque, increased acceleration, wheelies, racetracks with short straights
    • Add tooth on front/reduce teeth on rear = increased top end speed, open road cruising, lowers RPMs, better gas mileage, tracks with long straights
    • 1 down on the front is like adding 3 teeth on the rear
    • The bigger the rear sprocket, the lower the gearing and the faster the acceleration
    ⚠ WARNING: California Proposition 65 www.P65Warnings.ca.gov.

    RECENTLY VIEWED PRODUCTS

    BACK TO TOP