TST Plug and Play Adjustable LED Flasher Relay - Honda Monkey 125 (ALL YEARS)

A must-have for those converting to LED turn signal lights. Will work with both LED lights and standard light bulbs. You can control the rate in which it blinks by popping off the cover with a small flat head screwdriver. Best of all there is no rewiring. Plug and play for 2018-2026 Honda Monkey 125!

The flasher relay is needed when you convert your turn signal to LED.

Installation tips:

1. The flasher relay on the monkey is located below the Gas Tank.
2. Carefully plug the relay into the harness connector, to insure that the pins do not bend or go sideway.

Features

• Slows signaling flash rate back to the normal rate when your bike goes into hyperflash state (or your signals stay on constantly)
• Adjustable functionality to speed up or slow down flash rate to your preference
• Plug and play installation: simply replaces the relay already on your bike
• Fits like OEM
• Relay housing is flexible so that you can access the adjustment dial inside the unit

This component works with the following signal configurations:

1. All stock
2. Stock taillight, aftermarket signals
3. Integrated taillight, stock signals
4. Integrated taillight, aftermarket signals.

The relay comes preset to 85 cycles per minute. You can alter the flash rate to make it faster or slower. If you slip off the grey cover you can access an adjuster that will enable you to change the flash rate to your liking.

INTERNATIONAL BUYERS: Please make sure your bike uses a 2-pin relay for the signaling system. If your bike has hazard lights it may need the 4-pin relay. Please also note the pin configuration and make sure it matches what is on your bike. IT IS YOUR RESPONSIBILITY TO VERIFY FITMENT BEFORE MAKING YOUR PURCHASE. If you happen to have a 4-pin relay, this relay will NOT work Again, it is your responsibility to verify fitment before making final purchase.

RELAY FUNCTIONALITY NOTE: A moment of rapid flash during initial signal activation of a ride cycle is normal.